ISO 2307:2019 ファイバーロープ—特定の物理的および機械的特性の決定 | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives ).

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents ).

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see www.iso.org/iso/foreword.html .

This document was prepared by Technical Committee ISO/TC 38, Textiles.

This fifth edition cancels and replaces the fourth edition (ISO 2307:2010), which has been technically revised. The main changes compared to the previous edition are as follows:

• inclusion of diameter in the scope, and describe methods to measure it;
• changes in test length;
• changes in test speed;
• inclusion of another method for determination of realization factor in Annex B;
• addition of a sample of a test report (Annex D).

1 Scope

This document specifies, for ropes of different kinds, a method of determining each of the following characteristics:

• linear density;
• diameter;
• lay length;
• braid pitch;
• elongation;
• breaking force.

This document also provides a method for measuring water repellence, lubrication and finish content, when requested by the customer.

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

3 Terms and definitions

For the purposes of this document, the terms and definitions given in ISO 1968 in ISO 9554 and the following apply.

ISO and IEC maintain terminological databases for use in standardization at the following addresses:

Bibliography