ISO 10059-1:2025 緻密形状耐火物 ―冷間圧縮強さの求め方― その1:保圧なしの審判試験 | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives ).

ISO draws attention to the possibility that the implementation of this document may involve the use of (a) patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed patent rights in respect thereof. As of the date of publication of this document, ISO had not received notice of (a) patent(s) which may be required to implement this document. However, implementers are cautioned that this may not represent the latest information, which may be obtained from the patent database available at www.iso.org/patents . ISO shall not be held responsible for identifying any or all such patent rights.

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see www.iso.org/iso/foreword.html .

This document was prepared by Technical Committee ISO/TC 33, Refractories.

This third edition cancels and replaces the second edition (ISO 10059-1:1992), which has been technically revised.

The main changes are as follows:

• revised definitions;
• addition of the possibility to use cube shaped test piece;
• addition of an informative annex on precision and bias.

A list of all parts in the ISO 10059 series can be found on the ISO website.

Introduction

The ISO 10059 series comprises two parts. This document (ISO 10059-1) specifies a referee method for determination of the cold compressive strength, which does not use any packing material. ISO 10059-2 will specify an alternative test where packing material and alternative test piece sizes are permitted.

The test method for shaped insulating products is given in ISO 8895.

1 Scope

This document specifies a method for determination of the cold compressive strength of dense shaped refractory products.

Shaped refractories are those which have fixed geometry and dimensions when delivered to the user. This document is accordingly applicable to standard shape refractory bricks, but also special shapes refractory products and pre-cast products.

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

3 Terms and definitions

For the purposes of this document, the following terms and definitions apply.

ISO and IEC maintain terminology databases for use in standardization at the following addresses:

Bibliography