ISO 16433:2006 抵抗溶接—コーティングされていないおよびコーティングされた低炭素鋼のシーム溶接の手順 | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, 2.

The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights.

ISO 16433 was prepared by the International Institute of Welding, recognized as an international standardizing body in the field of welding in accordance with Council Resolution.

Introduction

Requests for official interpretations of provisions in this standard should be made in writing and sent to the ISO Central Secretariat who will forward them to the IIW Secretariat for an official response.

1 Scope

This International Standard specifies requirements for resistance seam welding in the fabrication of assemblies of uncoated and metallic coated low carbon steel comprising two sheets of metal, where the maximum single sheet thickness of components to be welded is within the range 0,4 mm to 3 mm for the following materials:

• uncoated steels;
• hot-dip zinc or iron-zinc alloy (galvannealed) coated steel;
• electrolytic zinc, zinc-iron, or zinc-nickel coated steel;
• aluminium coated steel;
• zinc-aluminium coated steel.

Organic-coated or primer-coated steels are not covered by this International Standard. Guidelines for the design of appropriate seam welding equipment and welding conditions are given in Annexes A and B. These are for guidance only and may need to be adapted to suit the specified service conditions of the fabrication, prevailing production conditions, type of welding equipment, mechanical and electrical characteristics of the welding machine, electrode configuration, and material. These requirements shall be taken from the relevant welding procedure specification for the application or procedure, where these exist.

2 Normative references

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

3 Terms and definitions

For the purposes of this document, the terms and definitions given in ISO 669 and ISO 14329 and the following apply.

Bibliography