ISO 22760-6:2024 道路車両 — ジメチルエーテル (DME) 燃料システムコンポーネント — Part 6:圧力リリーフバルブ (PRV) | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types of ISO document should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives ).

ISO draws attention to the possibility that the implementation of this document may involve the use of (a) patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed patent rights in respect thereof. As of the date of publication of this document, ISO had not received notice of (a) patent(s) which may be required to implement this document. However, implementers are cautioned that this may not represent the latest information, which may be obtained from the patent database available at www.iso.org/patents . ISO shall not be held responsible for identifying any or all such patent rights.

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see www.iso.org/iso/foreword.html .

This document was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 41, Specific aspects for gaseous fuels.

A list of all parts in the ISO 22760 series can be found on the ISO website.

1 Scope

This document specifies definitions of and general requirements to a pressure relief valve for limiting internal pressure of dimethyl ether (DME) fuel containers intended for use on the types of motor vehicles as defined in ISO 3833. It also provides general design principles and specifies requirements for instructions and marking.

This document is applicable to vehicles using gaseous fuels in accordance with ISO 16861. It is not applicable to the following:

• a) fuel containers for any application other than as noted above;
• b) stationary, ship, railroad vehicle or aircraft DME engine installations;
• c) fuel container mounting hardware;
• d) parts of vehicle fuel systems other than the fuel container;
• e) electronic fuel management;
• f) refuelling receptacles.

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies:

3 Terms and definitions

For the purposes of this document, the terms and definitions given in ISO 22760-1 and the following apply.

ISO and IEC maintain terminology databases for use in standardization at the following addresses:

Bibliography