ISO 2870:2009 界面活性剤—洗剤—酸性条件下で加水分解性および非加水分解性の陰イオン活性物質の測定 | ページ 2

※一部、英文及び仏文を自動翻訳した日本語訳を使用しています。

序文

ISO (国際標準化機構) は、各国の標準化団体 (ISO メンバー団体) の世界的な連合です。国際規格の作成作業は、通常、ISO 技術委員会を通じて行われます。技術委員会が設立された主題に関心のある各会員団体は、その委員会に代表される権利を有します。 ISOと連携して、政府および非政府の国際機関もこの作業に参加しています。 ISO は、電気技術の標準化に関するすべての問題について、国際電気標準会議 (IEC) と緊密に協力しています。

国際規格は、ISO/IEC 指令で指定された規則に従って起草されます。 2.

技術委員会の主な任務は、国際規格を準備することです。技術委員会によって採択されたドラフト国際規格は、投票のためにメンバー団体に配布されます。国際規格として発行するには、投票するメンバー団体の少なくとも 75% による承認が必要です。

このドキュメントの要素の一部が特許権の対象となる可能性があることに注意してください。 ISO は、そのような特許権の一部または全部を特定する責任を負わないものとします。

ISO 2870 は、欧州標準化委員会 (CEN) 技術委員会 CEN/TC 276,表面活性剤が、技術委員会 ISO/TC 91,表面活性剤と協力して、ISO と CEN 間の技術協力に関する協定に従って作成されました。 (ウィーン協定)

この第 3 版は、技術的に改訂された第 2 版 (ISO 2870:1986) を取り消して置き換えるものです。

次の大きな変更が導入されました: 電位差二相滴定の導入。

1 スコープ

この国際規格は、洗剤中の酸性条件下で加水分解可能な陰イオン活性物質と加水分解されない陰イオン活性物質の測定方法を規定しています。

この活性物質には、アルキル硫酸塩とヒドロキシ硫酸塩、およびアルキルフェノールと脂肪アルコールのエトキシ硫酸塩が含まれます。

活性物質の 2 種類の平均相対分子量は、それらの含有量が質量パーセントで表される場合、既知であるか、事前に決定されている必要があります。洗剤に酸化剤が含まれている場合は、加水分解の前にこれを破壊する必要があります。

2 参考文献

本書の適用には、以下の参考文献が不可欠です。日付のある参考文献については、引用された版のみが適用されます。日付のない参照については、参照文書の最新版 (修正を含む) が適用されます。

  • ISO 607, 界面活性剤および洗剤 - サンプル分割の方法
  • ISO 2271, 界面活性剤 — 洗剤 — 手動または機械式直接二相滴定手順による陰イオン活性物質の測定
  • ISO 3696, 分析ラボ用水 — 仕様および試験方法
  • EN 14480, 界面活性剤 - 陰イオン界面活性剤の測定 - 電位差二相滴定法

参考文献

[1]Reid, VW et al., Tenside 5 , 1968, pp. 90-96

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, 2.

The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights.

ISO 2870 was prepared by the European Committee for Standardization (CEN) Technical Committee CEN/TC 276, Surface active agents, in collaboration with Technical Committee ISO/TC 91, Surface active agents, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement).

This third edition cancels and replaces the second edition (ISO 2870:1986) which has been technically revised.

The following major change was introduced: introduction of the potentiometric two-phase titration.

1 Scope

This International Standard specifies a method for the determination, in detergents, of anionic-active matter hydrolyzable and non-hydrolyzable under acid conditions.

This active matter includes alkyl sulfates and hydroxysulfates and alkylphenol and fatty alcohol ethoxysulfates.

The mean relative molecular mass of the two types of active matter must be known or previously determined, if their content is expressed as a percentage by mass. If the detergent contains any oxidizing agent, this must be destroyed before the hydrolysis.

2 Normative references

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

  • ISO 607, Surface active agents and detergents — Methods of sample division
  • ISO 2271, Surface active agents — Detergents — Determination of anionic-active matter by manual or mechanical direct two-phase titration procedure
  • ISO 3696, Water for analytical laboratory use — Specification and test methods
  • EN 14480, Surface active agents — Determination of anionic surface active agents — Potentiometric two-phase titration method

Bibliography

[1]Reid, V.W. et al., Tenside 5, 1968, pp. 90-96