ISO 29862:2018 粘着テープ  —  剥離接着特性の決定 | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives ).

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents ).

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation on the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see the following URL: www.iso.org/iso/foreword.html .

This document was prepared by Technical Committee ISO/TC 61, Plastics, Subcommittee SC 11, Products.

This second edition cancels and replaces the first edition (ISO 29862:2007) of which it constitutes a minor revision.

The changes compared to the previous edition are as follows:

• the normative references in Clause 2 have been updated;
• definitions have been added in Clause 3 for “self adhesive tape”, “liner” and “double sided adhesive tape”;
• a Bibliography has been added;
• the text has been editorially revised to comply with the most recent editing rules.

1 Scope

This document specifies a series of methods for the determination of peel adhesion properties of self adhesives tapes.

This document contains:

• Method 1: Self adhesive tapes – Measurement of peel adhesion from stainless steel at an angle of 180°;
• Method 2: Self adhesive tapes – Measurement of peel adhesion from its own backing at an angle of 180°;
• Method 3: Self adhesive tapes – Measurement of peel adhesion of double sided and transfer tapes at an angle 180°;
• Method 4: Self adhesive tapes – Measurement of adhesion of the liner to an adhesive tape at an angle of 180°.

Annexes A and B specify further variations in the testing protocol according to specific conditions.

A guide to the use of these methods is given in Table 1.

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

3 Terms and definitions

For the purposes of this document, the terms and definitions given in EN 12481 and the following apply.

ISO and IEC maintain terminological databases for use in standardization at the following addresses:

Bibliography