ISO 3337:2000 円筒シャンクとタップ穴のあるモールステーパーシャンクを備えたTスロットカッター | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, 3.

Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.

Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights.

International Standard ISO 3337 was prepared by Technical Committee ISO/TC 29, Small tools, Subcommittee SC 2, Drills, reamers, milling cutters and milling machine accessories.

This third edition cancels and replaces the second edition (ISO 3337:1978), which has been technically revised in particular with the addition of threaded shanks.

1 Scope

This International Standard specifies the dimensions of T-slot cutters with plain or flatted cylindrical shanks, with threaded shanks and with Morse taper shanks having tapped hole.

It applies to those tools which are intended for manufacturing T-slots for machine tools for equipment, in accordance with ISO 299.

T-slot cutters with plain cylindrical shanks or flatted cylindrical shanks and with threaded shanks are suitable for the production of slots in accordance with ISO 299 from 5 mm to 36 mm inclusive; those with Morse taper shanks are suitable for the production of slots in accordance with ISO 299 from 10 mm to 54 mm inclusive.

2 Normative references

The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards.

Bibliography