ISO 6301-2:2018 空気圧流体動力—圧縮空気ルブリケーター—パート2：サプライヤーの文献に含まれる主な特性を決定するための試験方法 | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, 1. In particular the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, 2 (see www.iso.org/directives ).

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents ).

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation on the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see the following URL: www.iso.org/iso/foreword.html .

This document was prepared by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee SC 5, Control products and components.

This third edition cancels and replaces the second edition (ISO 6301-2:2006), which has been technically revised.

The main changes compared to the previous edition are as follows:

• the normative references have been updated.

A list of all parts in the ISO 6301 series can be found on the ISO website.

Introduction

In pneumatic fluid power systems, power is transmitted and controlled through air under pressure within a circuit. Where lubrication of the air media is desired, compressed air lubricators are components designed to introduce the required quantity of lubricant into the air stream.

1 Scope

This document specifies tests, procedures and a method of presenting the results concerning the parameters that define the main characteristics to be included in the supplier’s literature of lubricators conforming to ISO 6301-1.

This document can be applied:

• to facilitate the comparison of lubricators by standardizing test methods and presentation of test data;
• to assist in the proper application of lubricators in compressed-air systems.

The tests specified are intended to allow comparison between the different types of lubricators; they are not production tests to be carried out on each lubricator manufactured.

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

3 Terms and definitions

For the purposes of this document, the terms and definitions given in ISO 5598 and ISO 6301-1 apply.

ISO and IEC maintain terminological databases for use in standardization at the following addresses:

Bibliography