ISO 6325:2024 船舶および海洋技術 — ケーブルストッパー | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types of ISO document should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives ).

ISO draws attention to the possibility that the implementation of this document may involve the use of (a) patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed patent rights in respect thereof. As of the date of publication of this document, ISO had not received notice of (a) patent(s) which may be required to implement this document. However, implementers are cautioned that this may not represent the latest information, which may be obtained from the patent database available at www.iso.org/patents . ISO shall not be held responsible for identifying any or all such patent rights.

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see www.iso.org/iso/foreword.html .

This document was prepared by Technical Committee ISO/TC 8, Ships and marine technology, Subcommittee SC 4, Outfitting and deck machinery.

This third edition cancels and replaces the second edition (ISO 6325:1987), which has been technically revised.

The main changes are as follows:

• Figure 3, a combined track and roller stopper with adjust block has been added;
• 4.2, the nominal size of the cable stopper corresponding to the nominal size of anchor chain has been added according to ISO 1704;
• 5.1, designed environmental conditions and material requirements have been added;
• 5.7, location design requirements of cable stopper have been added;
• Clause 6, functional, operational and installation requirements have been added;
• Clause 7, acceptance tests requirements have been added;
• Annex A and Annex B have been deleted.

1 Scope

This document specifies requirements for the types, sizes, design, construction, strength, safety, function, operation, installation and acceptance tests of cable stoppers.

This document is applicable to the design, manufacturing and acceptance tests of cable stoppers for use with marine windlasses and anchor capstans as defined in ISO 4568.

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

3 Terms and definitions

For the purposes of this document, the terms and definitions given in ISO 3828, ISO 4568 and the following apply.

ISO and IEC maintain terminology databases for use in standardization at the following addresses:

Bibliography