この規格 プレビューページの目次
※一部、英文及び仏文を自動翻訳した日本語訳を使用しています。
序文
ISO (国際標準化機構) は、各国の標準化団体 (ISO メンバー団体) の世界的な連合です。国際規格の作成作業は、通常、ISO 技術委員会を通じて行われます。技術委員会が設立された主題に関心のある各会員団体は、その委員会に代表される権利を有します。 ISOと連携して、政府および非政府の国際機関もこの作業に参加しています。 ISO は、電気技術の標準化に関するすべての問題について、国際電気標準会議 (IEC) と緊密に協力しています。
国際規格は、ISO/IEC 指令のPart 2 部で規定されている規則に従って作成されます。
技術委員会の主な任務は、国際規格を準備することです。技術委員会によって採択されたドラフト国際規格は、投票のためにメンバー団体に配布されます。国際規格として発行するには、投票するメンバー団体の少なくとも 75% による承認が必要です。
このドキュメントの要素の一部が特許権の対象となる可能性があることに注意してください。 ISO は、そのような特許権の一部または全部を特定する責任を負わないものとします。
ISO 7579 は、技術委員会 ISO/TC 35, 塗料およびワニス、小委員会 SC 2, 顔料および増量剤によって作成されました。
この第 2 版は、混合時間を 24 時間から 3 時間に短縮し、温度を 105 °C から 150 °C に引き上げた第 1 版 (ISO 7579:1990)、方法 B および附属書 B を取り消して置き換えます。が削除され、測光試験法が追加されました。
序章
多くの染料は、過剰の染料が存在する限り、溶媒中に存在する染料の量とは無関係な程度まで溶媒に溶解する。この濃度は飽和濃度として定義され、溶媒中の染料の溶解度を表します。しかし、場合によっては、固定された飽和濃度がなく、溶解する染料の量が染料の添加量とともに増加します。これらの染料の溶解度を評価するための重量法および測光法は、この国際規格に記載されています。
1 スコープ
この国際規格は、有機溶媒中の染料の溶解度を決定するための 2 つの方法を指定しています。それらは、溶媒の影響下で化学的に変化せず、指定された乾燥条件下で安定しており、不揮発性である染料に適用できます。揮発性溶媒 (沸点 < 120 °C) の場合は重量法が推奨され、揮発性の低い溶媒 (沸点 > 120 °C) の場合は測光法が推奨されます。手続きの選択は、ケースバイケースで行う必要があります。
この方法は、溶媒 1 リットルあたり 1 g から 1,000 g の濃度の染料に適しています。溶液の粘度が手順を容易に実行できるようなものであれば、より高い濃度を使用することができます。
この方法は、染料中の不溶物の測定には適していません。
2 参考文献
本書の適用には、以下の参考文献が不可欠です。日付のある参考文献については、引用された版のみが適用されます。日付のない参照については、参照文書の最新版 (修正を含む) が適用されます。
- ISO 787-2, 顔料および増量剤の一般的な試験方法 — Part 2: 105 °C での揮発性物質の測定
- ISO 2811-1, 塗料およびワニス — 密度の測定 — Part 1: ピクノメーター法
- ISO 15528塗料、ワニス、および塗料とワニスの原材料 — サンプリング
3 用語と定義
このドキュメントでは、次の用語と定義が適用されます。
3.1
溶解性
特定の条件下で特定の溶媒の所定の体積に溶解する染料の最大質量
注記 1:溶解度は溶媒 1 リットル当たりのグラム数で表す (附属書 A を参照) 「真の」溶解度と「コロイド状」の溶解度は区別されません。
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 7579 was prepared by Technical Committee ISO/TC 35, Paints and varnishes, Subcommittee SC 2, Pigments and extenders.
This second edition cancels and replaces the first edition (ISO 7579:1990), in which the mixing time has been reduced from 24 h to 3 h but the temperature has been increased from 105 °C to 150 °C, Method B and Annex B have been deleted and a photometric test method has been added.
Introduction
Many dyestuffs are soluble in a solvent to an extent which is independent of the amount of dyestuff present in the solvent, as long as excess dyestuff is present. This concentration is defined as the saturation concentration and represents the solubility of the dyestuff in the solvent. In some cases, however, there is no fixed saturation concentration and the amount of dyestuff which dissolves increases with the amount of dyestuff added. A gravimetric and a photometric procedure to assess the solubility of these dyes are described in this International Standard.
1 Scope
This International Standard specifies two methods for determining the solubility of dyestuffs in organic solvents. They are applicable to dyestuffs that do not change chemically under the influence of the solvent and are stable and non-volatile under the specified drying conditions. For volatile solvents (boiling point < 120 °C), the gravimetric procedure is recommended and, for less volatile solvents (boiling point > 120 °C), the photometric procedure is recommended. The choice of procedure should be made on a case-by-case basis.
The methods are suitable for concentrations between 1 g and 1 000 g of dyestuff per litre of solvent. Higher concentrations can be used provided the viscosity of the solution is such that the procedure can be carried out readily.
The methods are not suitable for the determination of insoluble matter in a dyestuff.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
- ISO 787-2, General methods of test for pigments and extenders — Part 2: Determination of matter volatile at 105 °C
- ISO 2811-1, Paints and varnishes — Determination of density — Part 1: Pyknometer method
- ISO 15528, Paints, varnishes and raw materials for paints and varnishes — Sampling
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
3.1
solubility
maximum mass of a dyestuff that is soluble in a given volume of a particular solvent under specified conditions
Note 1 to entry: Solubility is expressed in grams per litre of solvent (see Annex A). No distinction is made between “true” solubility and “colloidal” solubility.