ISO/IEC 10536-2:1995 識別カード—非接触型集積回路カード—パート2：結合領域の寸法と位置 | ページ 2

3.3.1 ID-1 ISO/IEC 7810 で定義されているとおり

Foreword

ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work.

In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote.

International Standard ISO/IEC 10536-2 was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 17, Identification cards and related devices.

ISO/IEC 10536 consists of the following parts, under the general title Identification cards — Contactless integrated circuit(s) cards:

• Part 1: Physical characteristics
• Part 2: Dimensions and location of coupling areas
• Part 3: Electronic signals and reset procedures

Annexes A to C of this part of ISO/IEC 10536 are for information only.

1 Scope

This part of ISO/IEC 10536 specifies the dimensions, location, nature and assignment of each of the coupling areas to be provided for interfacing slot or surface card coupling devices (CCDs) with contactless integrated circuit(s) cards (CICCs) of the ID-1 card type.

This part of ISO/IEC 10536 does not specify:

• The dimensions, location and assignment of coupling elements on the CICC;
• The dimensions, location and assignment of coupling elements on the CCD;
• The means of generating coupling fields.

This part of ISO/IEC 10536 is to be used in conjunction with ISO/IEC 10536-1.

Annex A shows the determination of the X and Y axes which are used in relating the field locations to the CICC.

Annex В shows examples of coupling elements in both a CICC and a CCD.

The dimensions used throughout this part of ISO/IEC 10536 are shown as nominal and expressed in millimetres; the figures shown are not drawn to scale.

2 Normative references

The following standards contain provisions which, through reference in this text, constitute provisions of this part of ISO/IEC 10536. At the time of publication, the editions indicated were valid. All standards are subject to revision and parties to agreements based on this part of ISO/IEC 10536 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards.

3 Definitions, abbreviations and symbols

3.1 Definitions

For the purposes of this part of ISO/IEC 10536, the definitions given in ISO/IEC 10536-1 and the following definitions apply.

3.2 Abbreviations

3.2.1 CICC

Contactless Integrated Circuit(s) Card as defined in ISO/IEC 10536-1.

3.2.2 CCD

Card Coupling Device as defined in ISO/IEC 10536-1.

3.3 Symbols

Annex C

Bibliography