ISO 22477-1:2018 地盤調査と試験—地盤構造の試験—パート1：杭の試験：静的圧縮荷重試験 | ページ 2

Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.

The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives ).

Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents ).

Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.

For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see www.iso.org/iso/foreword.html .

This document was prepared by the European Committee for Standardization (CEN) Technical Commitee CEN/TC 341, Geotechnical Investigation and Testing, in collaboration with ISO Technical Committee ISO/TC 182, Geotechnics, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement).

A list of all parts in the ISO 22477 series can be found on the ISO website.

This corrected version of ISO 22477-1:2018 incorporates the following corrections:

• Figure 1 a), added the ground surface level and corrected the"floating" reaction load;
• adjusted the scales for Figure 1 a) to e) to be consistent.

1 Scope

This document establishes the specifications for the execution of static pile load tests in which a single pile is subjected to an axial static load in compression in order to define its load-displacement behaviour.

This document is applicable to vertical piles as well as raking piles.

All types of piles are covered by this document. The tests considered in this document are limited to maintained load tests. Pile load tests with constant penetration rate and cyclic load tests are not covered by this document.

This document provides specifications for the execution of static axial pile load tests:

• a) checking that a pile will behave as designed;
• b) measuring the resistance of a pile.

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

3 Terms, definitions and symbols

For the purposes of this document, the terms and definitions given in EN 1990, EN 1997-1, EN 1997-2 and the following apply.

ISO and IEC maintain terminological databases for use in standardization at the following addresses:

3.1 Terms and definitions

3.2 Symbols