※一部、英文及び仏文を自動翻訳した日本語訳を使用しています。
序文
ISO (国際標準化機構) は、国家標準化団体 (ISO メンバー団体) の世界的な連合体です。国際規格の作成作業は通常、ISO 技術委員会を通じて行われます。技術委員会が設立された主題に関心のある各会員団体は、その委員会に代表される権利を有します。政府および非政府の国際機関も ISO と連携してこの作業に参加しています。 ISO は、電気技術の標準化に関するあらゆる事項について、国際電気標準会議 (IEC) と緊密に協力しています。
この文書の作成に使用される手順と、そのさらなる保守を目的とした手順は、ISO/IEC 指令Part に記載されています。特に、さまざまなタイプの ISO 文書に必要なさまざまな承認基準に注意する必要があります。この文書は、ISO/IEC 指令Part の編集規則に従って起草されました ( www.iso.org/directives を参照)
この文書の要素の一部が特許権の対象となる可能性があることに注意してください。 ISO は、かかる特許権の一部またはすべてを特定する責任を負わないものとします。文書の作成中に特定された特許権の詳細は、序論および/または受け取った特許宣言の ISO リストに記載されます ( www.iso.org/patents を参照)
本書で使用されている商号は、ユーザーの便宜のために提供された情報であり、推奨を構成するものではありません。
適合性評価に関連する ISO 固有の用語や表現の意味の説明、および貿易の技術的障壁 (TBT) における WTO 原則への ISO の準拠に関する情報については、次の URL を参照してください。 序文 - 補足情報
この文書を担当する委員会は、ISO/TC 85, 原子力エネルギー、核技術、および放射線防護、SC 5 分科会、核燃料サイクルです。
この第 2 版は、第 1 版 (ISO 8300:1987) を廃止し、置き換えるものであり、そのマイナーリビジョンを構成します。
導入
この国際規格で指定されている方法は、プルトニウムの酸化とその後の重量測定に基づいています。不純物の含有量が測定された場合は、それを考慮して補正が行われます。
特定の条件を考慮すると、1 回の測定 (重量測定および不純物補正) での全体の標準偏差は 0.1% 未満になることがあります。
1 スコープ
この国際規格は、不揮発性不純物の質量分率が 0.65% 未満である核グレード品質の二酸化プルトニウム (PuO 2 ) 中のプルトニウム含有量を測定するための、正確かつ正確な重量法を規定しています。
この方法は、二酸化プルトニウムの会計分析をクロスチェックするために使用されます。
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives ).
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents ).
Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO's adherence to the WTO principles in the Technical Barriers to Trade (TBT) see the following URL: Foreword - Supplementary information
The committee responsible for this document is ISO/TC 85, Nuclear energy, nuclear technologies, and radiological protection, Subcommittee SC 5, Nuclear fuel cycle.
This second edition cancels and replaces the first edition (ISO 8300:1987), of which it constitutes a minor revision.
Introduction
The method specified in this International Standard is based on an oxidation of the plutonium followed by weighing. If the content of impurities is measured, a correction is made to allow for them.
Respecting certain conditions, the overall standard deviation on a single determination (gravimetric determination and impurities correction) can be below 0,1 %.
1 Scope
This International Standard specifies a precise and accurate gravimetric method for determining the plutonium content in plutonium dioxide (PuO2) of nuclear grade quality, containing a mass fraction of less than 0,65 % of non-volatile impurities.
The method is used to cross-check accountancy analyses of plutonium dioxide.