この規格 プレビューページの目次
※一部、英文及び仏文を自動翻訳した日本語訳を使用しています。
1 スコープ
このテクニカル レポートでは、発火、炎の広がり、熱発生率、および煙の基本値に関する情報を、内張りおよびその他の建築製品の火災成長モデルで使用して、限られた数のシナリオで火災の危険性を説明する方法について説明します。小さな部屋での火の開発。その他のシナリオには、大きなコンパートメントでの延焼や廊下への延焼などがあります。
使用するモデルの種類は次のとおりです。
- a)火災の成長物理学に基づいた数学的モデル。これは、火災安全工学の目的で使用される可能性のある火災室の変数を計算します。他の
- b)一般化された工学計算。
全体の一貫性が損なわれない限り、サブモデルを上記のモデルに含めることができます。
一般に、モデルは 1 つの火災シナリオに限定されません。
モデルは、最終使用条件における建築製品の火災特性を計算および記述するために使用する必要があります。モデルの使用は、困難な材料によって制限されるべきではありませんが、一部の製品はモデル化できない場合があることが認識されています (たとえば、複雑なアセンブリや熱可塑性のため)
モデルの入力パラメータは、主に ISO/TR 3814 の ISO テストに基づいています。
壁と天井のライニングの火災モデルの品質は、表面製品のフルスケールの小部屋テストのテスト結果との比較、およびモデル自体の感度分析によって評価されます。
1 Scope
This Technical Report describes how information on basic values for ignition, spread of flame, rate of heat release and smoke can be used in fire growth models for internal linings and other building products to describe the fire hazard in a limited number of scenarios starting with fire development in a small room. Other scenarios include fire spread in a large compartment and fire propagation down a corridor.
The types of models to be used are:
- a) mathematical models based on fire growth physics, which calculate fire room variables, the results of which may be used for fire safety engineering purposes; and
- b) generalized engineering calculations.
Sub-models can be included within the above models, provided the consistency of the whole is not prejudiced.
The models in general are not limited to one fire scenario.
The models should be used to calculate and describe the fire properties of building products in their end-use conditions. The use of models should not be limited by difficult materials, but it is recognized that some products may not be capable of being modelled (for example due to their complex assembly or to their thermoplastic properties).
Input parameters for models are based on ISO tests, mainly those in ISO/TR 3814.
The quality of a fire model for wall and ceiling linings is assessed by comparison with test results from a full-scale small room test for surface products and by sensitivity analysis on the model itself.