この規格 プレビューページの目次
※一部、英文及び仏文を自動翻訳した日本語訳を使用しています。
1 スコープ
ISO 1268 のこの部分では、バルク成形コンパウンド (BMC) の試験片を射出成形する際に従うべき一般原則を指定し、再現可能な成形条件の確立に使用する 1 種類の試験片を準備するための金型設計の詳細を示します。必要に応じて、ISO 1268 のこの部分を射出成形用に配合されたシート モールディング コンパウンド (SMC) に適用することができます。その目的は、成形プロセスの主要パラメータの記述における統一性を促進し、成形条件の報告における統一的な慣行を確立することです。同等の結果が得られる試験片を再現可能に調製するために必要な特定の条件は、使用する材料ごとに異なります。これらの条件は、関連する材料の国際規格で規定されているか、利害関係者間で合意される必要があります。
注記テストでは、金型の設計が試験片の再現性のある準備において重要な要素であることが示されています。
ISO 1268 のこの部分は、ISO 1268-1 と併せて読むことを目的としています。
1 Scope
This part of ISO 1268 specifies the general principles to be followed while injection moulding test specimens of bulk moulding compound (BMC) and gives details of mould designs for preparing one type of specimen for use in establishing reproducible moulding conditions. Where appropriate, this part of ISO 1268 may be applied to sheet moulding compound (SMC) formulated for injection moulding. Its purpose is to promote uniformity in describing the main parameters of the moulding process and also to establish uniform practice in reporting moulding conditions. The particular conditions required for the reproducible preparation of test specimens which will give comparable results will vary for each material used. These conditions are given in the International Standard for the relevant material or are to be agreed upon between interested parties.
NOTE Tests have shown that mould design in an important factor in the reproducible preparation of test specimens.
This part of ISO 1268 is intended to be read in conjunction with ISO 1268-1.