この規格 プレビューページの目次
※一部、英文及び仏文を自動翻訳した日本語訳を使用しています。
導入
この国際規格は、空港で身体の不自由な乗客の民間輸送機への昇降、乗り降りに使用される搭乗車両の機能要件と安全要件を規定しています。
この国際規格全体を通じて、最低限必要な基準はキーワード「shall」の使用によって特定されています。推奨基準はキーワード「すべき」の使用によって識別され、必須ではありませんが、効果的で本質的に安全な乗車車両を提供する上で最も重要であると考えられています。推奨基準からの逸脱は、慎重な検討、広範なテスト、徹底的なサービス評価によって代替方法が満足できることが示された後にのみ発生します。
この国際規格の要件は、該当する SI 単位で表され、そのシステムを使用する国での便宜のために括弧内でおおよそのインチとポンドの単位が変換されています。正確な値を使用する必要があるとみなされる場合は、SI 単位のものが使用されます。 。
Introduction
This International Standard specifies the functional and safety requirements for boarding vehicles used at airports for elevation, boarding and disembarkation of reduced mobility passengers to/from civil transport aircraft.
Throughout this International Standard, the minimum essential criteria are identified by use of the key word “shall”. Recommended criteria are identified by use of the key word “should” and, while not mandatory, are considered to be of primary importance in providing effective and intrinsically safe boarding vehicles. Deviation from recommended criteria should only occur after careful consideration, extensive testing, and thorough service evaluation have shown alternate methods to be satisfactory.
The requirements of this International Standard are expressed in the applicable SI units, with approximate inch-pound units conversion between brackets for convenience in those countries using that system. Where it is deemed necessary to use exact values, the SI unit ones are to be used.